Description
The Luminous NXG 1150 is a microprocessor-controlled 850VA (750W) 12V Pure Sine Wave Solar Hybrid IPS and Home UPS inverter with a built-in solar charge controller. Operating on a single 12V DC battery bank, it intelligently blends solar PV power and utility grid electricity to supply clean AC power to connected appliances while maintaining optimal battery charge.
It is engineered for homeowners, retail shopkeepers, remote professionals, and small office operators who want dependable power backup alongside lower monthly electricity bills. Across Bangladesh—where frequent load shedding, rising electricity tariffs, and wide voltage fluctuations (90V–290V AC) affect daily routines—the Luminous NXG 1150 maximizes daytime solar energy utilization while keeping a reliable battery reserve ready for utility outages.
Key Features
-
850VA / 750W Rated Output Capacity: Comfortably powers ceiling fans, LED lights, a television, Wi-Fi router, and essential office electronics within its 750W rating.
-
Pure Sine Wave Output: Delivers smooth, low-distortion AC power safe for sensitive electronics and inductive motors.
-
In-Built Solar Charge Controller with iSOT: Integrates Intelligent Solar Optimization Technique (iSOT) and Intelligent Load Sharing (ILS) to prioritize solar energy and reduce grid draw.
-
Single 12V Battery Architecture: Operates on one 12V battery and supports Tubular, Flat Plate, and SMF/VRLA battery chemistries.
-
3 User-Selectable Saving Modes: Configure Solar, Solar + Grid, or Grid + Solar priority modes to match local outage schedules and energy-saving targets.
-
Wide Mains Input Voltage Range (90V–290V): Tolerates severe grid voltage swings without excessive battery discharge.
-
Informative LCD Display & Protections: Shows real-time solar charging, mains, and battery statistics alongside overload, short-circuit, deep-discharge, and overcharge protection.
Technical Advantages
-
Intelligent Solar & Load Sharing: Dynamically balances daytime loads between solar PV panels and the utility grid, helping save roughly 1.5 to 3 units of electricity per day under suitable sunlight conditions.
-
Clean Waveform for Sensitive Appliances: Pure sine wave output prevents motor hum in ceiling fans and protects power supplies in routers, laptops, and desktop computers.
-
i-Charge Fast Charging Support: Enables faster battery recovery from the grid during periods of heavy load shedding or cloudy weather.
-
Single-Battery Cost Efficiency: Runs on a single 12V battery and supports 12V-class solar panels (up to 850Wp within 18V–25V Voc), keeping installation straightforward.
-
Clear Diagnostics & Low Maintenance: Multi-parameter LCD readouts and solid-state protection simplify daily monitoring and upkeep.
Applications
-
Residential: Apartments, single-family homes, and rural residences running ceiling fans, LED lights, televisions, and Wi-Fi routers with rooftop solar support.
-
Commercial: Retail shops, pharmacies, diagnostic sample points, and POS billing counters.
-
Industrial: Light workshop control desks, testing benches, and auxiliary lighting circuits.
-
Factory: Administrative offices, security cabins, and small monitoring stations.
-
Office: Small offices, home workstations, networking routers, and CCTV surveillance setups.
-
Project Installation: Off-grid and hybrid solar backup retrofits for classrooms, telecom repeaters, and security hubs.
Why Choose This Product?
-
Proven Brand Engineering: Manufactured by Luminous, a widely trusted name in solar and power backup systems.
-
Backup Reliability + Daily Bill Savings: Combines a 750W pure sine wave IPS with an integrated solar charge controller to cut grid dependency during sunny hours.
-
Adaptable Operating Modes: Three user-selectable priority modes plus ECO/UPS selection let you optimize for maximum solar savings or maximum battery readiness.
-
Local Purchase & Support: Available through loopshop.com.bd with convenient online ordering and customer support in Bangladesh.
Technical Specification Table
| Specification | Details |
| Model | NXG 1150 |
| Brand | Luminous |
| Rated Power | 750 W (850 VA class) |
| Voltage | 12V DC (Single Battery) / 90V–290V AC Mains Input / 18V–25V DC Solar Voc |
| Current | Solar Charge Controller Rating: 40A–50A (Variant Dependent) |
| Frequency | 50 Hz |
| Efficiency | >80% (Battery Mode) |
| Protection | Overload, Short Circuit, Deep Discharge, Overcharge, Reverse Polarity |
| Dimension | 32.0 x 30.2 x 13.0 cm (320 x 302 x 130 mm) |
| Weight | 11.0 kg – 11.5 kg |
| Operating Temperature | Indoor Ambient Operation |
| Warranty | Official Manufacturer Warranty Applicable. |
Features List
-
✓ 850VA / 750W pure sine wave output on a single 12V battery
-
✓ In-built solar charge controller with Intelligent Solar Optimization Technique (iSOT)
-
✓ Supports up to 850Wp 12V solar PV panels (18V–25V Voc)
-
✓ 3 user-selectable priority modes: Solar, Solar + Grid, and Grid + Solar
-
✓ Compatible with 12V Tubular, Flat Plate, and SMF/VRLA batteries
-
✓ Wide grid input acceptance range (90V–290V AC) plus ECO and UPS modes
-
✓ Informative LCD display with overload, short-circuit, and deep-discharge protection
Benefits For Customers
-
Lowers Monthly Electricity Bills: Intelligent solar prioritization uses rooftop solar power first to charge the battery and run daytime appliances.
-
Protects Sensitive Electronics: Pure sine wave output keeps ceiling fans, routers, laptops, and LED TVs running quietly without electrical hum or resets.
-
Handles Bangladesh Voltage Fluctuations: Wide mains operating window (90V–290V) maintains reliable performance even when grid voltage drops.
-
Flexible Mode Control: Switch easily between maximum solar savings and grid-assisted fast charging depending on weather and load shedding.
Installation & Maintenance Guide
Installation Requirements:
-
Install the inverter indoors on a dry, level surface or battery trolley in a well-ventilated room with at least 15 cm of clearance around cooling vents.
-
Connect a single compatible 12V battery using heavy-gauge copper battery cables with clean, tight terminal lugs.
-
Connect 12V-class solar panels (within the 18V–25V Voc and up to 850Wp limit) through a DC MCB/isolator with correct positive (
+) and negative (-) polarity. -
Configure the battery-type selector and operating priority mode (Solar / Solar + Grid / Grid + Solar) before powering on.
-
Connect the AC mains input to a properly earthed wall socket or MCB-protected line and wire only approved backup loads to the output.
Maintenance Tips:
-
Clean dust and bird droppings from rooftop solar panels monthly using water and a soft cloth to maintain peak solar charging efficiency.
-
Inspect battery terminals and solar DC connections every 2 to 3 months for corrosion or loose lugs and keep them clean and secure.
-
For flooded Tubular or Flat Plate batteries, check electrolyte levels monthly and top up strictly with distilled water.
-
Wipe dust from the inverter cabinet and cooling vents with a dry cloth so airflow remains unobstructed.
Safety Instructions:
-
Always verify DC polarity (
+and-) for both the 12V battery and solar PV array before making connections. -
Never exceed the specified solar PV open-circuit voltage (Voc 18V–25V) or connect high-voltage string panels to this 12V hybrid inverter.
-
Do not connect heavy high-wattage appliances such as air conditioners, geysers, electric irons, microwaves, or water pumps to the inverter output.
-
Switch off the inverter and isolate solar PV, AC mains, and battery terminals before performing any wiring work or servicing.
FAQ Section
Q: What is the price of Luminous NXG 1150 in Bangladesh?
A: Prices for the Luminous NXG 1150 Solar Hybrid IPS Inverter in Bangladesh generally range between BDT 13,300 and BDT 18,500 for the inverter unit alone, depending on current import pricing and seller stock. Please check the current price listed on loopshop.com.bd for the latest offer.
Q: Where can I buy Luminous NXG 1150 in Bangladesh?
A: You can buy the Luminous NXG 1150 online in Bangladesh from loopshop.com.bd, with delivery available across Dhaka, Chattogram, Sylhet, Khulna, Rajshahi, and all districts.
Q: What warranty does this product have?
A: The Luminous NXG 1150 inverter unit comes with a 24-month (2-year) warranty. Check the product warranty terms at purchase for coverage details.
Q: Is this suitable for Bangladesh climate?
A: Yes. With a wide 90V–290V AC grid operating range, built-in solar charging, and ventilated indoor enclosure, it is well suited for Bangladesh’s warm weather, abundant sunlight, and frequent load-shedding conditions.
Q: How to install this product?
A: Place the inverter in a ventilated indoor spot, connect a single 12V battery with matching + and - polarity, wire compatible 12V solar panels (18V–25V Voc) through a DC isolator, set the battery type and operating mode switches, and connect AC input and backup load wiring. Professional electrician installation is recommended.
Q: Can the Luminous NXG 1150 work without solar panels at first?
A: Yes. It functions as a standard 12V Pure Sine Wave IPS/UPS using utility grid charging, allowing you to add solar panels later whenever ready.
Q: What solar panels are compatible with the NXG 1150?
A: It supports 12V-class solar panels with an open-circuit voltage (Voc) between 18V and 25V, up to 850Wp total array capacity (wired in parallel).
Q: Are the battery and solar panels included in the price?
A: No, the inverter unit is listed separately unless a specific bundle is stated on the product page. A compatible 12V battery and solar panels are purchased separately.
Q: What battery types can be used with Luminous NXG 1150?
A: It supports single 12V Tubular, Flat Plate, and SMF/VRLA batteries via its battery type selector.
Q: Can I run a Wi-Fi router or computer on this solar IPS?
A: Yes. Its pure sine wave output and UPS mode are designed to support Wi-Fi routers, computers, ceiling fans, and LED lights within the 750W rating.

Reviews
There are no reviews yet.